FlightLights v5.0 Controller

FlightLights v5.0 Controller

Intelligent, high power 20W LED Driver

54,00 €
In den Warenkorb
  • momentan leider ausverkauft

Our most advanced controller yet! Incorporating a high performance switching power regulator, the controller can drive up to 4A of LEDs from any kind of battery in the voltage range of 6 - 42V (e.g. 2S - 10S LiPo).


This advanced lighting controller permits the remote switching of navigation, strobe and landing lights, has ten flash patterns and incorporates ultra-scale rotating beacon simulation.


Compatible with high voltage receiver systems and a wide variety of LED types, the controller can drive up to 16 of our light modules, a total of 4A continuous load. The controller isolates the LED power supply from your receiver, safeguarding your radio's power supply from the high current demands of the light modules. There are lighting channels for navigation lights, landing light and two strobes.


The landing light and optionally the navigation lights are remotely switchable, and the controller can learn the receiver signals that you want it to switch at allowing easy integration with flap and landing gear systems. The ten flash patterns cover every aircraft we know of!


Compatible with standard servo connectors, the controller requires no soldering and is truly "plug and play", it's auto-power feature removing the need for a separate switch harness for the lights.


An electronic copy of the controller's manual is available here: FlightLights v5 Manual (PDF)


NOTE THAT THE CONTROLLER WILL HEAT UP TO 60-70°C WHEN RUN AT HIGH LOADS - PLEASE TAKE THIS INTO ACCOUNT IN YOUR INSTALLATION!

Features

  • High power, intelligent LED driver
  • Integral 4A switching power regulator supports 2S-10S LiPo batteries
  • Plug-and-play - no soldering required, use servo extension leads for wiring
  • Enhanced, more realistic strobe effect
  • Permits the remote switching of navigation, strobe and landing lights
  • 10 Flash Patterns, all FAA compliant and true scale
  • Rotating Beacon Simulation on one or both strobe channels
  • Independent LED power supply - safe guards your receiver
  • Can learn the servo signals for switching
  • Compatible with high voltage receivers
  • Low voltage protection for your LED battery

Specifications

  • Controller Dimensions: 72mm long x 24mm x 17mm
  • Controller Weight: 35g
  • Receiver Voltage: 4V - 13V
  • Receiver Current: 100mA
  • LED Supply Input: 6 - 42V
  • Cables: Approx. 30cm, universal servo connectors, 10cm JST battery connector